Davone Tulip
TULIP
Two Bass Drivers
With two powerful 6-inch woofers working in parallel, distortion is reduced for the low and mid frequencies. The total radiating area is actually larger than the 7-inch woofer used in Riva. A clean mid range reproduction is further more ensured through use of the same diaphragm compostion with natural fibers of the Riva and Ray mid driver.
Integrated Grill
For critical listening the grille is usually removed from the loudspeaker. By intergrating the grille into the design, this is no longer needed with the Tulip. Only 3mm thick, the sound is not at all blocked anymore by the grille. By fixing it to the cabinet, it is furthermore no longer a potential source of resonance.
Inert Baffle
The 24mm thick curved baffle is pressed into shape from 6 layers of High Density Fiber board (HDF). It provides optimal structural strength for the two powerful 6-inch woofers and the 1-inch tweeter. The cuts on the side enable the use of flat dowels to further strengthen the connection between the baffle and the cabinet walls.
Specifications
| Frequency response: | 43 - 30,000 Hz |
| Impedance: | 4 ohm, 2.7 ohm minimum at 43Hz |
| Sensitivity: | 88 dB/2.83V/m |
| Max power: | 100 W (IEC 268-5) |
| Woofer: | 150mm, proprietary natural fibre cone. Extended copper sleeve on pole piece for low distortion. Xmax 20 mm peak-peak |
| Mid: | 150mm, low distortion driver with a special fibre blend cone with optimal balance of stiffness, damping and density |
| Tweeter: | 29mm ring radiator, dual balanced compression chamber, saturation controlled motor system, non-reflective rear chamber with optimized damping |
| Crossover: | 2.1 kHz / Bottom woofer 100 Hz low pass |
| System: | Bass reflex |
| Cabinet: | 6 layer beech wood form pressed veneer |
| Weight: | 11 kg / piece |
Dimensions
